Fusion Support Services has developed a new tensile rated pulling head for directional drilling or boring which requires HDPE pipe to be pulled back after drilling is complete. The pulling head has a swivel eye bolt which will swivel 360 degrees and pivot 180 degrees. This swivel ability eliminates the HDPE pipe from twisting during pull back, which can cause the eye bolt to break and also reduces stress on the pipe. The pulling head is reinforced from the inside with resin which sandwiches double steel plates and heavy hex nuts to prevent the eyebolt from pulling through the HDPE head. The pulling heads have a 2x1 safety factor. HDPE pulling heads are available in sizes from 2 inch to 24 inches with different tensile strengths available. For additional information contact Fusion Support Services toll free at 800-994-HDPE or by e-mail at firstname.lastname@example.org.